Tool Steel Selection for Cold Extrusion, Cold Heading & Thread Rolling Dies
Select tool steel by compressive stress, sliding friction, shock loading, fatigue resistance, wear resistance, and cracking risk. For cold extrusion, cold heading, and thread rolling dies, the main choice is usually between compressive strength, wear resistance, and toughness.
Quick Selection Guide by Tool Steel Grade
Choose the grade according to the die application, working pressure, impact load, wear level, and whether the steel is used as an active die component or a supporting shrink ring.
Acero de alta velocidad M2 1.3343 / SKH51
Recommended for cold extrusion punches and die inserts under high compressive stress and severe sliding friction.
Acero para herramientas D2 1.2379 / SKD11 / Cr12Mo1V1
Recommended for cold extrusion die inserts and punches where abrasion resistance is critical.
Acero para herramientas A2 1.2363 / SKD12
Recommended for cold extrusion of softer materials and precision thread rolling dies.
Acero para herramientas H11 1.2343 / SKD6
Recommended for shrink rings, housings, and difficult extrusion tooling where cracking remains a problem.
Acero para herramientas H13 1.2344 / SKD61
Recommended for tough shrink rings and housings used to support cold extrusion die inserts.
Acero para herramientas S1 1.2550
Recommended for cold heading dies with intricate shapes, deep configurations, or sharp corners.
Acero para herramientas S7 1.2355
Recommended when cold heading or forming dies require stronger toughness against shock loading.
Selection Summary
This table gives a faster comparison when the buyer already knows the die application and main failure risk.
| Die Application | Requisito principal | Aobo Steel Grades |
|---|---|---|
| Cold extrusion punches and die inserts | High compressive strength, wear resistance, and fatigue resistance | M2, D2 |
| Cold extrusion of softer materials | Balanced toughness, wear resistance, and dimensional stability | A2 |
| Cold extrusion shrink rings and housings | Tough support against internal pressure and splitting risk | H11, H13 |
| Cold heading dies with cracking risk | Shock resistance and toughness | S1, S7 |
| Long-run cold heading inserts | Higher wear resistance in supported insert design | D2, M2 |
| Flat thread rolling dies | Abrasion resistance against steel blanks | D2 |
| Cylindrical or fine-pitch thread rolling dies | Precision, toughness, and low heat-treatment distortion | A2 |
| Long-run thread rolling and high-tensile fasteners | Compressive strength and wear resistance | M2 |
Need Tool Steel for Cold Extrusion, Cold Heading or Thread Rolling Dies?
Send your grade, size, quantity, and die application. Aobo Steel can support bulk supply of tool steel round bars and plates for industrial buyers.